Yamaha 2A - Page 69

E
4-6
EMU00339
8 Flushing in a Water Tank
cC
If the fresh water level is below the level
of the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
1) Remove the engine top cowling and
silencer cover.
2) Install the outboard motor on the
water tank.
3) Fill the tank with fresh water to above
the level of the anti-cavitation plate.
4) Run the engine at a fast idle for 10~15
minutes.
5) Just prior to turning off the engine,
quickly spray “Yamaha Stor-Rite
Engine Fogging Oil” (Part No. LUB-
STRRT-12-00) alternately into each
carburetor. When properly done, the
engine will smoke excessively and
almost stall.
6) Remove the motor from the water
tank.
7) Install the silencer cover and top
cowling.
1 Water surface
2 Lowest water level
605016*
q
w
6A1-9-1L 4 4/20/01 11:58 AM Page 7