EasyManua.ls Logo

Yamaha E115A - START-IN-GEAR PROTECTION

Yamaha E115A
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E
1-9
Yamaha dealers stock a range of pro-
pellers, and can advise you and install a
propeller on your outboard that is best suit-
ed to your application.
NOTE:
At full throttle and under a maximum boat
load, the engine’s rpm should be within the
upper half of the full throttle operating
range, as listed in “SPECIFICATIONS” on
page 4-1. Select a propeller which fulfills
this requirement.
If operating under conditions which allow
the engine’s rpm to rise above the maxi-
mum recommended range (such as light
boat loads), reduce the throttle setting to
maintain the rpm in the proper operating
range.
1 Propeller diameter (in inches)
2 Propeller pitch (in inches)
3 Type of propeller (propeller mark)
Refer to the section “CHECKING PRO-
PELLER” for instructions on propeller
removal and installation.
EMU01208
START-IN-GEAR PROTECTION
Yamaha outboard motors which have the
pictured label 1 affixed to them or Yamaha
approved remote control units are equipped
with start-in-gear protection device(s). This
feature permits the engine to be started
only when it is Neutral. Always select
Neutral before starting the engine.
13 x 17 - K
qwe
000933
602022
14-1/2 x 17 - M
qwe
000376
q
13-3/4 x 17 - ML
602033
qwe
60H-9-E1-1 3/1/02 9:25 PM Page 14

Table of Contents

Other manuals for Yamaha E115A

Related product manuals