Need help?Do you have a question about the Yamaha F225F and is the answer not in the manual?
General| Max Output | 225 HP |
|---|---|
| Gear Ratio | 1.86:1 |
| Compression Ratio | 10.0:1 |
| Starting System | Electric |
| Lubrication System | Wet Sump |
| Cooling System | Water Cooled |
| Full Throttle RPM Range | 5000-6000 RPM |
| Engine Type | 4-Stroke |
| Cylinder Arrangement | V6 |
| Fuel System | Electronic Fuel Injection (EFI) |
| Shaft Length | 25" |
| Ignition System | TCI |
| Recommended Fuel | 87 octane or higher |
| Oil Capacity | 6.3 L |
Proper use of the engine shut-off cord to prevent runaway boats.
Safety precautions for handling flammable gasoline and its vapors.
Detailed dimensions, weight, and performance data of the motor.
Specifies recommended fuel types and engine oil grades.
Guidelines for installing the outboard motor safely.
Proper procedures for mounting the outboard motor.
Advice on choosing the right propeller for optimal performance.
Detailed requirements for engine oil.
Guidance on fuel types, octane, and gasohol.
Illustrated overview of outboard motor parts.
How to operate the forward, reverse, and throttle controls.
Proper use of the shut-off cord and clip for safety.
Information on the 6Y9 gauge display and alerts.
What happens when the engine overheats.
Indicates low oil pressure and required actions.
Alert for water accumulation in the fuel filter.
Indicates low battery voltage and necessary steps.
Indicates general engine malfunctions.
Specifics of the low oil pressure alert.
Specifics of the engine overheat alert.
Specifics of the water separator alert.
Specifics of the low battery voltage alert.
Initial procedures before operating the motor.
Recommended break-in process for new engines.
Essential checks before starting the engine.
Checks and safety for the fuel system.
Inspecting the engine shut-off cord for damage.
Procedure for checking the engine oil level.
Verifying the operation of the trim and tilt system.
Steps for safely filling the fuel tank.
Safety warnings regarding exhaust gases and ventilation.
Step-by-step guide to starting the engine safely.
Final checks before starting the engine.
Detailed steps for starting the outboard motor.
Verifying steady flow from the cooling water pilot hole.
How to shift gears smoothly into forward and reverse.
Safe methods for stopping the boat.
Steps for safely stopping the engine.
Adjusting the motor's trim angle for performance.
Detailed steps for adjusting trim angle with power trim.
Procedures for tilting the outboard motor.
Step-by-step guide for tilting the motor up.
Step-by-step guide for tilting the motor down.
Safety and procedures for transporting and storing.
Steps for storing the outboard motor for extended periods.
Procedure for flushing cooling passages with fresh water.
General tasks for periodic maintenance.
Schedule for initial and recurring maintenance tasks.
Gear oil replacement and greasing points.
Schedule for 1000-hour maintenance tasks.
Inspection and replacement of propeller and spark plugs.
To Next Page
