Maintenance
79
7. Insert the tube of the oil changer into the
oil dipstick guide, and then extract the
engine oil completely.
8. Add the correct amount of oil through the
filler hole. NOTICE: Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level
mark, drain until the level meets the
specified capacity.
[ECM01851]
9. Install the oil filler cap and oil dipstick.
10. Leave the outboard motor for 5-10 min-
utes.
11. Remove the oil dipstick and wipe it
clean.
12. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
13. Recheck the oil level using the dipstick
to be sure the level falls between the up-
per and lower marks. Consult your
Yamaha dealer if the oil level is out of
specified level.
14. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there
are oil leaks, stop the engine and find
the cause. Continued operation with
a problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01623]
15. Install the top cowling.
16. Dispose of used oil according to local
regulations.
1. Oil changer
Recommended engine oil:
YAMALUBE 4 or 4-stroke outboard
motor oil
Engine oil quantity (without oil filter
replacement):
6.0 L (6.34 US qt, 5.28 Imp.qt)
Engine oil quantity (with oil filter re-
placement):
6.3 L (6.66 US qt, 5.54 Imp.qt)
1. Oil dipstick
2. Upper mark
3. Lower mark
6CE-9-74-1E0.book 79 ページ ２０１４年１２月４日 木曜日 午前９時３０分
To Next Page
Loading...
