Yamaha F225F - Page 87

Maintenance
80
TIP:
 For more information on the disposal of
used oil, consult your Yamaha dealer.
 Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
Changing the engine oil by draining the oil
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2. Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
3. Stop the engine and leave it for 5-10
minutes.
4. Remove the top cowling.
5. Remove the screws.
6. Remove the bolts.
7. Remove the apron from starboard side
as shown in the illustration.
ZMU05843
1. Screw
1. Bolt
1
ZMU07956
1
1
1
1
ZMU07957
6CE-9-74-1E0.book 80 ページ ２０１４年１２月４日 木曜日 午前９時３０分