Maintenance
82
specified capacity. [ECM01851]
12. Install the oil filler cap.
13. Leave the outboard motor for 5-10 min-
utes.
14. Remove the oil dipstick and wipe it
clean.
15. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
16. Recheck the oil level using the dipstick
to be sure the level falls between the up-
per and lower marks. Consult your
Yamaha dealer if the oil level is out of
specified level.
17. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there
are oil leaks, stop the engine and find
the cause. Continued operation with
a problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01623]
18. Install the apron on the starboard side as
shown in the illustration.
Recommended engine oil:
YAMALUBE 4 or 4-stroke outboard
motor oil
Engine oil quantity (without oil filter
replacement):
6.0 L (6.34 US qt, 5.28 Imp.qt)
Engine oil quantity (with oil filter re-
placement):
6.3 L (6.66 US qt, 5.54 Imp.qt)
1. Oil dipstick
1. Oil dipstick
2. Upper mark
3. Lower mark
6CE-9-74-1E0.book 82 ページ ２０１４年１２月４日 木曜日 午前９時３０分
To Next Page
Loading...
