E
3-13
EMU01707
Manual start models
7) Fully pull out the manual injection knob
firmly once. Release the knob to allow it
to automatically return to its home posi-
tion.
NOTE:
8 It is not necessary to use the manual
injection knob when restarting a warm
engine.
8 Pull out the manual injection knob twice
when the engine is brand new, after it has
been disassembled and reassembled for
inspection or repairs, and when starting
after a long period of storage.
209015
000560
8) Pull the starter handle slowly until you
feel resistance. Then give a strong pull
straight out to crank and start the
engine. Repeat if necessary.
9) After the engine starts, return the
starter handle slowly to its original posi-
tion before releasing it.
NOTE:
8 When starting a cold engine, the engine
needs to be warmed up. For further infor-
mation, see “Warming up engine” in this
chapter.
8 If the engine doesn’t start after pulling the
starter handle 3 or more times, repeat the
procedure from step 7. If the engine still
fails to start, see Chapter 5,
“Troubleshooting.”
60H-9-E1-3 3/1/02 9:38 PM Page 14
To Next Page
Loading...
