Yamaha F130 - Checks after Engine Warm up; Shifting; Stop Switches

Operation
67
Otherwise, serious engine damage
could occur. Consult your Yamaha
dealer.
[ECM02381]
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36981
Stop switches
 Turn the main switch to “ ”, or press the
engine stop button and make sure the en-
gine stops.
 Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
 Confirm that the engine cannot be started
with the clip removed from the engine shut-
off switch.
EMU33493
Shifting
WARNING
EWM00181
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
NOTICE
ECM01611
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
2. Move the remote control lever / gear shift
lever firmly and crisply forward (for for-
ward gear) or backward (for reverse gear)
[about 35° (a detent can felt) for remote
control models].
1. Neutral interlock trigger
1
ZMU01727
F
N
R
32˚
32˚
ZMU05460
U6EK35E0.book Page 67 Monday, December 10, 2018 9:06 AM
©2020 Yamaha Motor Corporation