E
4-7
605014*
q
6) Remove the motor from the water
tank.
7) Install the silencer cover and top
cowling.
1 Water surface
2 Lowest water level
EMU00342
8 Flushing with the Flushing Attachment
cC
Avoid running the outboard at high
speed while on the flushing attachment,
or overheating could occur.
1) Remove the top cowling and the pro-
peller.
2) Install a flushing attachment 1 to the
cooling water inlet.
3) Run the engine at a fast idle for 10~15
minutes supplying fresh water.
4) Just prior to turning off the engine,
quickly spray “Yamaha Stor-Rite
Engine Fogging Oil” (Part No. LUB-
STRRT-12-00) alternately into the
silencer cover. When properly done,
the engine will smoke excessively
and almost stall.
5) Remove the flushing attachment and
wipe off any excess water.
6) Install the top cowling and the pro-
peller.
NOTE:
A flushing attachment is available from a
Yamaha dealer.
65W-9-17-4 3/11/03 9:59 Page 8
To Next Page
Loading...
