Yamaha F40F - Electric and Prime Start Model Operations

Operation
50
EMU38632
Electric start / prime start models
WARNING
EWM01842
 Failure to attach the engine shut-off
cord could result in a runaway boat if
operator is ejected. Attach the engine
shut-off cord to a secure place on your
clothing, or your arm or leg while oper-
ating. Do not attach the cord to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
 Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. If the lock mode of the Yamaha Security
System is selected, use the remote con-
trol transmitter to select the unlock
mode. Short beep will sound twice when
unlocking the Yamaha Security System.
For further information, see page 18.
TIP:
 If you lost track of the current security
mode, press the lock or unlock button to
reset the security system.
 The signal transmission range of the re-
mote control transmitter varies depending
on the mounting position of the receiver.
To operate the Yamaha Security System
correctly, use the transmitter as close as
possible from the receiver.
 If Yamaha Security System may not oper-
ate correctly, repeat the activating proce-
dure once again.
2. Place the gear shift lever in neutral.
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
4. Place the throttle grip in the “ ”
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
6BG-9-78-1E0.book 50 ページ ２０１４年１１月２０日 木曜日 午後３時３分