Yamaha F40F - Remote Control Start Procedures

Operation
51
5. Turn the main switch to “ ” (start).
6. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “ ” (on). NOTICE: Never turn
the main switch to “ ” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
“ ” (on), wait 10 seconds, then
crank the engine again.
[ECM00193]
TIP:
 When the engine is cold, it needs to be
warmed up. For further information, see
page 53.
 If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 87.
EMU38642
Electric start and remote control models
WARNING
EWM01842
 Failure to attach the engine shut-off
cord could result in a runaway boat if
operator is ejected. Attach the engine
shut-off cord to a secure place on your
clothing, or your arm or leg while oper-
ating. Do not attach the cord to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
 Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. If the lock mode of the Yamaha Security
System is selected, use the remote con-
trol transmitter to select the unlock
mode. Short beep will sound twice when
unlocking the Yamaha Security System.
For further information, see page 18.
TIP:
 If you lost track of the current security
mode, press the lock or unlock button to
reset the security system.
 The signal transmission range of the re-
mote control transmitter varies depending
on the mounting position of the receiver.
To operate the Yamaha Security System
correctly, use the transmitter as close as
possible from the receiver.
 If Yamaha Security System may not oper-
6BG-9-78-1E0.book 51 ページ ２０１４年１１月２０日 木曜日 午後３時３分