PERIODIC MAINTENANCE AND ADJUSTMENT
7-26
7
EAUU1120
Replacing a rear turn signal
light bulb
1. Remove the rear turn signal lens
by removing the screw.
2. Remove the burnt-out bulb by pull-
ing it out.
3. Insert a new bulb into the socket
by pushing it in.
ECAU0080
NOTICE
_
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
_
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11191]
EAU25851
Troubleshooting
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
1. Rear turn signal lens
2. Screw
ZAUU0731
1
2
52BF8199E0.book Page 26 Friday, December 10, 2010 10:23 AM
To Next Page
Loading...
