80 En
Using multi-zone configuration
You can select and control Zone 2 by using the control
buttons on the front panel or on the remote control. The
available operations are as follows:
• Selecting the input source of Zone 2.
• Tuning into FM or AM when “TUNER” is selected as
the input source of Zone 2 (see page 45).
• Tuning into XM Satellite Radio when “XM” is selected
as the input source of Zone 2 (see page 48) (U.S.A. and
Canada models only).
• Tuning into SIRIUS Satellite Radio when “SIRIUS” is
selected as the input source of Zone 2 (see page 53)
(U.S.A. and Canada models only).
• Enjoying music stored on your iPod stationed in a
Yamaha iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK terminal of this
unit when “V-AUX” is selected as the input source
(see page 59).
• Enjoying music stored on your Bluetooth component
being performed “paring” operation with a Yamaha
Bluetooth adapter (such as YBA-10 sold separately)
connected to the DOCK terminal of this unit when “V-
AUX” is selected as the input source
(see page 61).
You must complete each step while the ZONE2 indicator is
flashing in the front panel display. Otherwise, the Zone 2 mode is
automatically canceled and this unit returns to the normal
operation mode. In this case, repeat the Zone 2 selection
procedure.
■ Controlling Zone 2 with the front panel
Turning on Zone 2
Press
K
ZONE CONTROL to turn on Zone 2.
Activating the Zone 2 operation mode
Press
K
ZONE CONTROL to control Zone 2.
The ZONE2 indicator flashes in the front panel display for
approximately 10 seconds.
Controlling Zone 2
Note
ZONE2
Flashes
01EN_HTR-6150_UC.book Page 80 Friday, February 1, 2008 11:21 AM
To Next Page
Loading...
Need help?
General
