PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Mixing Mode
Mixing Play
[F1] VOL/PAN
[F2] VOICE
[F3] EF SEND
[F4] TEMPLATE
[F5] VCE ED
[F6] EFFECT
Mixing Edit
Common Edit
[F1] GENERAL
[F2] MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Mixing Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Mixing Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Mixing Voice Job
[F2] RECALL
[F3] COPY
[F5] DELETE
Supplementary Information
119
[SF4] AEG (Amplitude EG)
From this display you can set the AEG parameters for each Part. The parameters offset the same parameters of the
assigned Voice set in the Voice mode (page 44). The parameters are the same as in Performance Part Edit. See page
68.
NOTE
The Sustain setting is not available for Parts to which Drum Voices have been assigned.
NOTE The Release setting is not available for Parts to which Drum Voices have been assigned.
From this display you can set how each individual Part responds to various MIDI data, such as Control Change and
Program Change messages. When the relevant parameter is set to “on,” the corresponding Part responds to the
appropriate MIDI data. Note that two different display types listed below are provided and you can switch between them
by pressing the [SF5] button. The two display types are linked and feature the same settings, only in different formats.
Use the type you feel most comfortable with.
Display showing four Parts
This display type shows the Receive Switch status for four Parts at a time. Set the desired Part on or off, for the
corresponding MIDI data type. To view and edit another set of four Parts, press the appropriate Number button, [1] to
[16].
Display showing all parameters for one Part
This display type shows all of the Receive Switch settings for a single selected Part. Set the desired MIDI data type on
or off for the selected Part. To select other Parts, use the Number [1] – [16] buttons (making sure that the [TRACK]
button is on). The function is the same as the one in the RCV SW display (page 69) in the Performance Part Edit mode.
In addition to the parameters which can be set in the Performance Part Edit mode, Program Change and Bank Select
can be set in this display of the Mixing mode.
[F5] RCV SW (Receive Switch)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
