8
Controls and features
Control function
Engine switch
The engine switch controls the ignition system.
Ignition circuit is switched on.
The engine can be started.
Ignition circuit is switched off.
The engine will not run.
Starting circuit is switched on.
The starter motor starts and the engine can be started.
After starting the engine, take your hand off the switch
immediately.
Oil warning light (Red)
When the oil level falls below the lower level, the oil
warning light comes on and then the engine stops
automatically. Unless you refill with oil, the engine will
not start again.
(Manual starting models)
If the engine stalls or does not start, turn the engine
switch to “ ” (ON) and then pull the recoil starter. If the
oil warning light flickers for a few seconds, the engine
oil is insufficient. Add oil and restart.
(Electric starting models)
If the engine stalls or does not start, turn the engine
switch to “ ” (START). If the oil warning light comes
on, the engine oil is insufficient. Add oil and restart.
2
1
1
2
3
1.
“ ” (ON)/“ ” (ON)
2.
“ ” (OFF)/“ ” (STOP)
3.
“” (START)
A Manual starting models
B Electric starting models
7VE-F8199-70-E0.book 8 ページ ２０１６年１１月１５日 火曜日 午後５時３５分
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
