32
Storage
Engine
Perform the following steps to protect the cylinder, pis-
ton ring, etc. from corrosion.
1. Remove the spark plug, pour about one table-
spoon of engine oil (See page 23) into the spark
plug hole and reinstall the spark plug only. Recoil
start the engine by turning over several times (with
ignition off) to coat the cylinder walls with oil.
2. Pull the recoil starter until you feel compression.
Then stop pulling. (This prevents the cylinder and
valves from rusting.)
3. Clean exterior of the multi-purpose engine and
apply a rust inhibitor.
4. Store the multi-purpose engine in a dry, well-venti-
lated place, with the cover placed over it.
5. The multi-purpose engine must remain in a vertical
position when stored, carried or operated.
7VE-F8199-70-E0.book 32 ページ ２０１６年１１月１５日 火曜日 午後５時３５分
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
