Recording Keyboard Performances
P-255 Owner’s Manual
29
3
Activate Record mode and select the
part whose settings you have changed.
Press the [REC] button followed by the [RIGHT]
or [LEFT] button. (If you have changed settings
common to both parts, select either the left or right
part.) Verify that the selected part’s button is flash-
ing in red.
If you wish to change the tempo, reverb, or effect,
please do so in this step.
To cancel the process without changing any set-
tings, press the [REC] button once again.
4
Save your changes.
Press the [PLAY/STOP] button with the [REC]
button held down. Dashes (“-”) will scroll across
the display to indicate that data is being saved.
When this process is complete, the message
“End” will be shown, followed by the song num-
ber. In addition, the instrument will automatically
leave Record mode.
• Take care not to play the keyboard or press the [PLAY/
STOP] button at this time. Either of these actions will
start recording and delete the data already recorded.
• You should never turn off the digital piano while dashes
(“-”) are scrolling across the display. Failure to observe
this precaution may result in all song data (page 21),
including Import Songs, being deleted.
To Next Page
Loading...
