Yamaha ProR3 - Reverb + Early Reflections (Rev + ER)

22 Advanced uses (2) – Editing functions –
ProR3 Digital Reverberator
Reverb + Early Reflections (Rev + ER)
Key Parameter Value Description
MAIN
REV RevTime 0.3 ~ 99.0 s
Refer to “Reverberation” items on page 18
REV IniDelay 0.1 ~ 200.0 ms
REV HighRatio X0.1 ~ X1.0
REV LowRatio X0.1 ~ X2.4
REV Diffusion 0 ~ 10
ER Type *1
*1 Small Hall, Large Hall, Random, Reverse, Plate, Strings
Refer to “Early reflection” items on page 19
ER IniDelay 0.1 ~ 100.0 ms
ER Liveness 0 ~ 10
ER RoomSize 0.1 ~ 25.0
ER Diffusion 0 ~ 10
FINE
ER/REV Balance *2
*2 Only when REV Patch is parallel (Reverb + ER)
0/100 ~ 100/0 Level balance of ER and reverb
REV Rev Mix *3
*3 Only when REV Patch is serial (Reverb → ER, ER → Reverb)
0 ~ 100% Reverb amount
REV Reverb Type *4
*4 Hall, Room, Vocal, Plate
Type of reverb tone
REV Density 0 ~ 100 Density of reverb
REV HPF Thru, 40 Hz ~ 1.0 kHz Cutoff frequency of reverb high pass filter
REV LPF 400 Hz ~ 20 kHz, Thru Cutoff frequency of reverb low pass filter
REV Space Mod 0 ~ 10 Modulation level of reverb
ER Number 1 ~ 14 Number of early reflections
ER Density 0 ~ 100 Density of early reflections
ER HPF Thru, 40 Hz ~ 1.0 kHz Cutoff frequency of ER high pass filter
ER LPF 400 Hz ~ 20 kHz, Thru Cutoff frequency of ER low pass filter
REV Patch *5
*5 Reverb + E.Ref., E.Ref. → Reverb, Reverb → E.Ref.
Connection of reverb and ER
Common parameters Refer to “Common parameters” on page 27