28 Advanced uses (2) – Editing functions –
ProR3 Digital Reverberator
Program paramaters 2 (Secondary effects)
DFL
By using the dynamic filter you can create wah effects in which the frequency response is
changed by the level of the input signal.
Key Parameter Value Description
FINE
DFL Dynamic Filter OFF, ON DFL effect on/off
DFL Filter Type LPF, HPF, BPF Filter type selection
DFL Frq.Center 100 Hz ~ 3.2 kHz Center frequency of the filter
DFL Resonance 0 ~ 20 Filter resonance
DFL Shift Up/Down
Direction in which center frequency will change in response
to the level of the input signal
DFL Sens 1 ~ 10 Sensitivity to the input signal
DFL Decay 1 ~ 10 Speed at which the center frequency will return after shifting
DFL Patch PreREV, PostREV Place the filter patch point before or after the reverb
continues to COMP
To Next Page
Loading...
