Yamaha PW50 2021 - Periodic Maintenance and Adjustment; Front Wheel Removal and Installation

Periodic maintenance and adjustment
7-23
7
EAU24361
Front wheel
EAU56510
To remove the front wheel
WARNING
EWA10822
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Place the motorcycle on the cen-
terstand.
2. Disconnect the brake cable at the
wheel hub by removing the front
brake lever free play adjusting nut,
then removing the cable from the
brake camshaft lever and brake
shoe plate.
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Install the brake shoe plate into
the wheel hub as shown.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
1. Brake camshaft lever
2. Brake shoe plate
3. Washer
4. Axle nut
5. Brake cable
6. Front brake lever free play adjusting nut
5
6
1
3
4
2
1. Wheel axle
1. Retainer
1
1
U2SA14E0.book Page 23 Monday, May 1, 2017 10:19 AM