EasyManua.ls Logo

Yamaha YB50 - Inspection of Brake Shoes; Inspection of Brake Fluid Level

Yamaha YB50
161 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSP
ADJ
INSPECTION OF BRAKE SHOES /
INSPECTION OF BRAKE FLUID LEVEL
3-13
NSPECTION OF BRAKE SHOES
1. Activate the brake lever
2. Inspect:
• Wear indicator
Indicator on wear limit line

Change
the brake shoes.
INSPECTION OF BRAKE FLUID LEVEL
NOTE:
Place the scooter upright when inspecting the
fluid level.
1. Inspect:
• Fluid level.
The fluid level is below the minimum
level line

Refill up to correct level.
ATTENTION:
The fluid may corrode painted surfaces or
plastic parts. Always clean any spilt fluid
immediately.
ss
WARNING:
• Only use fluid of the designated quality.
Otherwise the rubber seals may deterio-
rate due to leakages and poor performan-
ce of the brakes.
• Refill with the same type of fluid. The mix-
ture of fluids may cause a damaging che-
mical reaction which may cause the poor
performance of the brakes.
• Take care not to let water enter the pump
while it is being filled. The water will lower
the boiling point of the fluid significantly
and may cause a steam blockage.
Recommended fluid:
DOT 4

Table of Contents