Yamatake DMC10 Series User Manual

Digital Controller SIO Driver
GP-Pro EX Device/PLC Connection Manual
23
 Settings of External Device
To configure communication settings for the External Device, use the ENT, DISP, MODE, Down and Up keys on
the front of the Controller. You can change the communication settings only in READY mode. Switch the
External Device to READY mode before setting.
Refer to your Controller manual for details.
 Procedure
1 In the basic display, press the MODE key twice. In the RUN/READY mode switching display that appears, change to
READY mode.
2 In the basic display, press and hold the ENT and Down keys simultaneously for 3 seconds or more to display the
setup items.
3 Press the Down/Up keys to select a setup item and press the ENT key.
4 Use the Down/Up keys to select a setting and press the ENT key.
5 Press the DISP key to move to the basic display.
 Settings
Setup Items Settings
C31 1
C32 0
C33 0
• The parameters to be set vary depending on the Controller. Refer to your Controller manual
for details.

Yamatake DMC10 Series Specifications

General

Brand	Yamatake
Model	DMC10 Series
Category	Controller
Language	English