Digital Controller SIO Driver
GP-Pro EX Device/PLC Connection Manual
65
Settings of External Device
To configure communication settings for the External Device, use the PROG, RUN/HOLD, SETUP, ENT, DISP,
Down and Up keys on the front of the Controller. You can change the communication settings only in READY
mode. Switch the External Device to READY mode before setting.
Refer to your Controller manual for details.
Procedure
1 Press the
RUN/HOLD key
while holding down the
PROG key to move to READY mode.
2 In the basic display, press the SETUP key to move to the setup group.
3 Press the Down/Up keys several times to select a setup item and press the ENT key.
4 Use the Down/Up keys to select a setting and press the ENT key.
5 Press the DISP key to move to the basic display.
Settings
Setup Items Settings
C76 1
C77 0
C78 0
C79 0
C80 0
C97 0
• The parameters to be set vary depending on the Controller. Refer to your Controller manual
for details.
To Next Page
Loading...
Need help?
General
