Yanmar 1GM10C User Manual

PERIODIC MAINTENANCE
GM Series Operation Manual 63
12/05
Checking the Wiring Connectors
Consult authorized Yanmar Marine dealer
or distributor.
Inspecting and Adjusting the
Intake / Exhaust Valve Clearances
See Inspecting and Adjusting the
Intake / Exhaust Valve Clearances on
page 56. Consult authorized Yanmar
Marine dealer or distributor.
Inspecting and Adjusting the
Throttle and Shift Control Cables
See Inspecting and Adjusting the Throttle
and Shift Control Cables on page 56.
Perform the following maintenance every
1000 hours or every 4 years of operation,
whichever comes first.
• Inspecting the Fuel Injection Timing
• Inspecting the Seawater Pump
Impeller
• Checking and Adjusting the
Alternator V-Belt Tension
• Tightening All Major Nuts and Bolts
• Adjusting the Propeller Shaft
Alignment
Inspecting the Fuel Injection Timing
Consult authorized Yanmar Marine dealer
or distributor.
Inspecting the Seawater Pump
Impeller
See Inspecting the Seawater Pump
Impeller on page 61.
Checking and Adjusting the
Alternator V-Belt Tension
See Checking and Adjusting the Alternator
V-Belt Tension on page 56.
Tightening All Major Nuts and Bolts
See Tightening Fasteners on page 50 or
consult authorized Yanmar Marine dealer
or distributor.
Adjusting the Propeller Shaft
Alignment
See Adjusting the Propeller Shaft
Alignment on page 57. Consult authorized
Yanmar Marine dealer or distributor.
Every 1000 Hours of Operation
GM_OM.book 63 ページ ２０１３年６月１０日 月曜日 午後２時２６分

Yanmar 1GM10C Specifications

General

Type	Marine Diesel Engine
Cylinders	1
RPM	3600
Fuel System	Direct Injection
Lubrication system	Forced Lubrication
Fuel	Diesel
Power Output	9 HP
Cooling System	Freshwater cooling with heat exchanger
Starting system	Electric starter