INSPECTION AND MAINTENANCE
6LT Series Operation Manual
51
CHANGE THE ENGINE OIL
Figure 6
Proceed only with engine not running and at low
temperature to avoid any risk of burns.
The operations for emptying and filling the engine
oil are carried out by pressing the button located on
the panel of the relative electronic module; for
reasons of safety, the controls are only enabled
when the power is on but engine is not started.
• Place a container for collecting the spent oil
under the circuit charge/ discharge tap (1).
• Open the tap and move the button (A) on the
panel to DISCHARGE until the sump is
completely empty.
Figure 7
• Connect the tap to the container of the oil to be
added and move the button on the panel to
CHARGE until the specified quantity has been
filled.
• Reclose the charge/discharge tap and use the
dipstick to check that the oil quantity in the sump
is between the MIN and MAX limits.
• Dispose of used oil according to current
requirements.
To Next Page
Loading...
