INSPECTION AND MAINTENANCE
6LT Series Operation Manual
55
CHECK TENSION AND CONDITION OF AUXILIARY BELT
Figure 11
Proceed only with engine not running and at low
temperature to avoid any risk of burns.
• Remove the belt cover (1) from the pulley and the
belt.
Figure 12
• Check that the belt (1) is not worn, soiled with oil
or fuel, or showing signs of tears. If any of these
conditions are identified, replace the belt.
• Check the efficiency of the tensioner (3) using the
tool (2) on the tensioner as indicated in the figure.
• Reposition the belt cover in its seat and tighten
the fasteners.
To Next Page
Loading...
