INSPECTION AND MAINTENANCE
52
6LT Series Operation Manual
CHANGE ENGINE OIL FILTERS
Figure 8
NOTE: The following procedure is by way of example only.
Only use original Yanmar filters.
Only proceed once the engine is stationary and has been allowed to cool, and preferably after having
drained the waste oil, in order to avoid the risk of burns.
• Place a container under the filter support to collect the used oil.
• Unscrew and remove the filter (1).
• Carefully clean the surfaces.
• Apply a thin layer of oil on the sealing gasket of the new filters.
• Manually tighten the new filters on the bracket until it comes into contact with the gasket, then tighten by
3/4 of a turn.
• Dispose of the used filters according to the applicable regulations in force.
To Next Page
Loading...
