INSPECTION AND MAINTENANCE
54
6LT Series Operation Manual
CHANGE FUEL PRE-FILTER
Figure 10
Proceed only with the engine not running and at a low temperature to avoid any risk of burns:
1. Place a bowl to collect any fuel which may come out from the pre-filter.
2. Disconnect the electrical connection from the Drain Valve and Water Sensor.
3. Loosen the Drain Valve and let all the fuel drain out.
4. Remove the pre-filter from the mounting bracket.
5. Install the new filter element on the mounting bracket.
6. Reinstall the Drain Valve and Water Sensor in the filter.
7. Connect the electrical connection to the Water Sensor.
8. Open the Air Bleed Valve and work the hand priming pump until only fuel comes out.
9. Close the Air Bleed Valve.
Risk of injury
Dispose of consumable materials and the parts
in contact with them (for example filters) in
accordance with the law. The workshops of the
Service Network are equipped for this purpose.
Fuel Outlet
Fuel Inlet
Air Bleed Valve
Drain Valve and
Water Sensor
Ground Wire
To Next Page
Loading...
