Yanmar Lx450 - Replace the Side Lights Bulb; Replace the Tail Lights Bulb

15. SERVICE THE ELECTRICAL SYSTEM
15-6
Lx410/450/490 Operator's Manual
(A) Connector
(B) Boot
(C) Headlights bulb
(D) Retaining ring
■ Replace the Side Lights Bulb
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
5. Remove the key.
6. Raise the hood.
7. Rotate the bulb socket counterclockwise from the
side lights housing.
8. Remove the side lights bulb from the bulb socket.
(A) Side lights housing
(B) Side lights bulb
(C) Bulb socket
9. Insert new side lights bulb into the bulb socket.
10.Install the bulb socket clockwise into lock position.
11.Turn the starter key switch to ON position.
12.Turn on side lights switch.
13.Make sure the side light bulbs are functioning.
14.Lower the hood.
■ Replace the Tail Lights Bulb
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
5. Remove the key.
6. Remove the two screws and lens from the tail
lights housing.
7. Push down and rotate the tail lights bulb
counterclockwise to remove the tail lights bulb.
(A) Screw
(B) Lens
(C) Tail lights housing
8. Push the new tail lights bulb into the socket and
rotate tail lights bulb clockwise to lock position.
9. Turn the starter key switch to ON position.
10.Turn on tail lights switch.
11.Make sure the tail lights bulbs are functioning.
12.Install the lens and screws.
P1110401
(A) (B) (C)
(D)
P1110405
(A)
(C)
(B)
NOTE
● The tail lights can be serviced after removing the
rear lens assembly.
(A)
(B)
P15_6_Tail lights