Yanmar Lx450 - Raise (Unfolded Up) the Roll-Over Protective Structure (ROPS); Operate the Tractor

8-4
8. OPERATE THE TRACTOR
Lx410/450/490 Operator's Manual
■ Raise (unfolded "up") the Roll-Over
Protective Structure (ROPS)
1. Pull out the hairpin clip from each of the insert
pins located on both sides of the Roll-Over
Protective Structure (ROPS).
2. Pull out the insert pins from both sides of the Roll-
Over Protective Structure (ROPS).
3. Raise (unfolded "up") the Roll-Over Protective
Structure (ROPS).
4. Retaining holes are located on both sides of the
Roll-Over Protective Structure (ROPS) in the
unfolded "up" position. Install the insert pins into
the holes.
5. Insert pin jam hole is located at the end of the
insert pin. Install the hairpin clip into the holes.
6. To secure the play-absorbing vibration-insulating
rubber block, pull the upper bolt to the near side
and insert the pins.
(A) Insert pin
(B) Insert pin jam hole
(C) Hairpin clip
1. Sit on the operator seat
Regarding how to adjust operator seat position, for
details, see "3. Adjust the Operator Seat" on
page 7-2.
Regarding how to fasten the retractable seatbelt, for
details, see "4. Fasten the Retractable Seatbelt" on
page 7-3.
IMG_4628od 1
(C)
(A)
(B)
450_P1080347
(C)
3. Operate the Tractor
● Before starting or operating the tractor,
always ensure there is no bystander or
obstacle.
● Push down Power Take Off (PTO) switch to
OFF position.
● Raise any implements.
IMPORTANT
● To prevent damage to the transmission, stop the
tractor completely before operating the:
• range gear lever
• forward/N/reverse lever
• 2WD/4WD lever
NOTE
● There is no need to stop the tractor before
operating the primary gear lever.
! WARNING