Yanmar SA Series - Lower (Folded Down) the Roll-Over Protective Structure (ROPS); Raise (Unfolded Up) the Roll-Over Protective Structure (ROPS)

8-3
8. OPERATE THE TRACTOR
SA221/324/424 Operation Manual
■ Lower (folded "down") the Roll-Over
Protective Structure (ROPS)
The Roll-Over Protective Structure (ROPS) can be
folded down only by approximately 90 degrees.
1. Pull out the hairpin clip from each of the insert
pins located on both sides of the Roll-Over
Protective Structure (ROPS).
2. Pull out the insert pins from both sides of the Roll-
Over Protective Structure (ROPS).
(A) Hairpin clip
(B) Insert pin
(C) Top bar of the Roll-Over Protective Structure
(ROPS)
3. Lower (folded "down") the Roll-Over Protective
Structure (ROPS).
4. Retaining holes are located on both sides of the
lowered Roll-Over Protective Structure (ROPS).
Install the insert pins into the holes.
5. Hole is found at the end of the insert pin. Install
the hairpin clip into the hole.
6. To secure the play-absorbing vibration-insulating
rubber block, pull the upper bolt to the near side
and insert the pins.
■ Raise (unfolded "up") the Roll-Over
Protective Structure (ROPS)
1. Pull out the hairpin clip from each of the insert
pins located on both sides of the Roll-Over
Protective Structure (ROPS).
2. Pull out the insert pins from both sides of the Roll-
Over Protective Structure (ROPS).
3. Raise (unfolded "up") the Roll-Over Protective
Structure (ROPS).
4. Retaining holes are located on both sides of the
Roll-Over Protective Structure (ROPS) in the
unfolded "up" position. Install the insert pins into
the holes.
5. Insert pin jam hole is located at the end of the
insert pin. Install the hairpin clip into the holes.
6. To secure the play-absorbing vibration-insulating
rubber block, pull the upper bolt to the near side
and insert the pins.
(A) Hairpin clip
(B) Insert pin
(C) Top bar of the Roll-Over Protective Structure
(ROPS)
(C)
(B)
(A)
(B)
(A)
(C)
SA221_324_424_OperatorsManual.book 3 ページ ２０１８年６月４日 月曜日 午後５時１９分