Yanmar SA Series - Disengage the Parking Brake; Practices for Safe Operation

8-12
8. OPERATE THE TRACTOR
SA221/324/424 Operation Manual
(A) Power Take Off (PTO) switch
(B) Parking brake lock lever
(C) Brake pedal
■ Disengage the Parking Brake
1. Depress the brake pedal fully.
2. Push the parking brake lever downward to unlock
the parking brake.
3. Release the brake pedal. Make sure that the
brake pedal is unlocked.
1. Drive the Tractor on Roads
(A) Typical example of installed Slow Moving
Vehicle (SMV) emblem
1. Turn the hazard lights and headlights ON, unless
prohibited by law.
2. Slowly drive the tractor to be able to control the
tractor at all times.
3. Slow down when:
• Traveling on slopes and rough roads.
• Executing sharp turns.
• Transporting a heavy rear mounted implement.
●Always park the tractor on a solid and level
ground. If parking on a slope is unavoidable:
• chock all the tires safely and securely
• engage the parking brake securely, for
details, see "6. Lock and Set the Parking
Brake" on page 7-3
(A)
(C)
(B)
! WARNING
7. Practices for Safe Operation
Exercise due caution when driving the tractor
on roads. Follow the following instructions.
●Turn on the hazard lights.
●Before operating the tractor on a road,
become familiar with the relevant state or
local regulations in effect.
●Always have an implement safety lighting kit
available from YOUR LOCAL YANMAR
TRACTOR DEALER.
●Use the turn signal lights during turning.
●Always keep the Slow Moving Vehicle (SMV)
emblem on the original position.
●Perform the following precautions:
• always ensure the Slow Moving Vehicle
(SMV) emblem and hazard lights are clean
and clearly visible
• always ensure that the Slow Moving Vehicle
(SMV) emblem is visible while a rear
mounted implement is mounted
! WARNING
(A)
SA221_324_424_OperatorsManual.book 12 ページ ２０１８年６月４日 月曜日 午後５時１９分