Yanmar SA Series - Using the 3-Point Hitch Controls

10-2
10. 3-POINT HITCH AND DRAWBAR
SA221/324/424 Operation Manual
■ Use the 3-Point Hitch Control Lever
1. Use the 3-point hitch control lever to raise and
lower the implement attached to the 3-point hitch.
2. Adjust the position stop knob to set the desired
lowest position of the implement from the ground.
<SA221>
<SA324/424>
(A) 3-point hitch control lever
(B) Position stop knob
(a) Moving the 3-point hitch control lever backward
raises the implement.
(b) Moving the 3-point hitch control lever forward
lowers the implement.
(c) Neutral (SA221)
■ Use the Position Stop Knob
1. Operate the attached implement.
2. Use the 3-point hitch control lever to establish the
desired working height (distance from the ground)
of the implement.
3. Loosen the position stop knob.
4. Move the position stop knob rearwards until
position stop knob stops against the 3-point hitch
control lever.
5. Tighten the position stop knob to fix on that
particular position.
• Every time the 3-point hitch control lever stops
against the position stop knob, the implement is
lowered to the established working height.
NOTE
● The 3-point hitch delivered with the tractor is a
Category 1.
NOTE
● The 3-point hitch control lever is labeled 1 to 9.
● The numbers:
• for reference purposes only
• does not indicate any exact height position for
the implement that is attached to the 3-point
hitch
● The lower the number, the closer the lower links
is to the ground.
(A)
(b) (a)(c)
NOTE
Use the position stop knob to:
● Limit the downward movement of the lower links.
● Set a minimum distance between the attached
implements and the ground.
(b)
(a)
(A)
(B)
10_3pointHitch.fm 2 ページ ２０１８年７月６日 金曜日 午前９時４７分