Yaohua Weighing System XK3190-C601 - Parameter for Control

10
[SET—2]: Parameter for control
Key function description at parameter setting status as
followed:
• [↑][↓][←][→]:Shift between digits or increase value at
digit
• [STOP]: Return to last parameter setting
• [ESC]: Return to weighing status
[SET-0]:
Press [SET] key, it will display [set-0], then press [ENTER]
key, operate step by step refer to following table:
[SET-1]:
Press [SET] key, it will display [set-0], press [↑] key until
it shows [set-1], then press [ENTER] key, operate step by step
refer to following table:
4
0-not clear; 1-clear
5
0-No need for these connection; 1-need for these connection
6
Parameter A:0-outside code display; 1-inner code display
Parameter B: 1~8
B 1 2 3 4 5 6 7 8
(e) 0.5 1 1.5 2 2.5 3 3.5 4
Parameter C,D:0~5
C,D 0 1 2 3 4 5
F.S% 0 2 4 10 20 100
Item
Display Parameter
description
Remark
1 [d**.**.**] Current date set Could set
2 [t**.**.**] Current time set Could set
3 [n ****] Accumulation time Check only
4 [A ******] Accumulation value Check only
5
[De1 0] Clear accumulation
value or not
4
Press[ENTER],
finish
Item Display Parameter description Remark
1
[H ABCD] Hardware configuration
5
A- PC connection
B- Scoreboard connection
C- Printer connection
D- Analog output
For example:
[H 1111]
2
[n ABCD] Zero parameter
6
A-
O
utside code or inner
code display
B- Zero tracking range
C- Manual zero range
D- Auto zero range
For example:
[n 0222]