33 support@yardistrystructures.com
Remember to push up centre to assist with alignment.
C: Starting at the bottom and working up loosely connect Roof Panel Assemblies through (729) Corner LT and
(737) Corner RT with three 1/4 x 2-3/4” Hex Bolts (with two 1/4-5/16” large washers and one 1/4” lock nut) per
side. To align bolt holes helper on the centre ladder may have to push up in the centre of the panels and others
make sure corners are aligned. Tighten bolts when all six have been installed. (g. 14.4 and 14.5)
(729) Corner LT and (737) Corner RT should be aligned with mitre in Beam Assembly. (g. 14.6)
Hardware
1/4” Lock
Nut
1/4 x 2-3/4”
Hex Bolt
Fig. 14.4
Fig. 14.5
Roof Panel
Assembly
Bottom
holes rst
x 3
Step 14: Attach Final Roof Panel
Part 2
6 x 1/4 x 2-3/4” Hex Bolt
(1/4-5/16” large washer x 2, 1/4” lock nut)
1/4-5/16”
Large Washer
Corner
LT & RT
Fig. 14.6
Corner LT and RT
aligned with mitre in
Beam Assembly
Parts removed for clarity
To Next Page
Loading...
