Yardistry YM11915 - Step 21: Attach Roof to Beam Brackets - Small Roof Assembly

57 support@yardistrystructures.com
75
64
Hardware
F21.1
F21.2
A: On each Small Roof Assembly, through the bolt hole at the bottom of the board, loosely attach one Roof to
Beam Bracket to each rafter with one 1/4 x 2” Hex Bolt (with two 1/4-5/16” large washers and one1/4” lock nut) per
bracket. (F21.1 and F21.2)
B: Push panels up from the outside and inside top to make sure each (648) So󰀩t is tight to the Short Beam
Assemblies then fasten each Roof to Beam Bracket with three #12 x 1-1/2” Pan Screws per bracket. Install top
screw into the rafter rst then install the other two into the beam. Slight gaps are normal. (F21.1 and F21.2)
C: Tighten all Roof to Beam Bracket bolts in both Small Roof Assemblies.
Step 21: Attach Roof to Beam Brackets -
Small Roof Assembly
(629) Rafter
Short RT
(630) Rafter
Short LT
Short Beam
Assembly
10 x 1/4 x 2” Hex Bolt
(1/4-5/16” large washer x 2, 1/4” lock nut)
30 x #12 x 1-1/2” Pan Screw
Inside View
Inside View
(634)
Rafter
(632) Rafter
Centre RT
(631) Rafter
Centre LT
Parts removed
for clarity
1/4 x 2” Hex Bolt
1/4”
Lock
Nut
1/4-5/16”
Large Washer
Rafter
Roof to Beam
Bracket
#12 x 1-1/2”
Pan Screw
Components
10 x Roof to Beam Bracket
Short Beam
Assembly
1/4-5/16”
Large Washer