xvii
Maintenance and Inspection Precautions
Disposal Precautions
General Precautions
Do not change any wiring while power is being supplied.
There is a risk of electric shock or injury.
Wiring and inspections must be performed only by qualified engineers.
There is a risk of electric shock or product failure.
Wait for at least six minutes after turning OFF the power supply (with a SERVOPACK for a 100-
VAC input, wait for at least nine minutes) and then make sure that the CHARGE indicator is not
lit before starting wiring or inspection work. Do not touch the power supply terminals while the
CHARGE lamp is lit after turning OFF the power supply because high voltage may still remain in
the SERVOPACK.
There is a risk of electric shock.
When disposing of the product, treat it as ordinary industrial waste. However, local ordinances
and national laws must be observed. Implement all labeling and warnings as a final product as
required.
Figures provided in this document are typical examples or conceptual representations. There
may be differences between them and actual wiring, circuits, and products.
The products shown in illustrations in this document are sometimes shown without covers or
protective guards. Always replace all covers and protective guards before you use the product.
If you need a new copy of this document because it has been lost or damaged, contact your
nearest Yaskawa representative or one of the offices listed on the back of this document.
This document is subject to change without notice for product improvements, specifications
changes, and improvements to the manual itself.
We will update the document number of the document and issue revisions when changes are
made.
Any and all quality guarantees provided by Yaskawa are null and void if the customer modifies
the product in any way. Yaskawa disavows any responsibility for damages or losses that are
caused by modified products.
To Next Page
Loading...
Need help?
General
