YASKAWA GA500 - Page 2

2 / 5
EZZ023995<1>
December 2019
2. Addition of Parameter Not Initialized when A1-03 = 2220, 3330 [Initialize
Parameters = 2-Wire Initialization, 3-Wire Initialization]
Even when you set A1-03 = 2220, 3330 [Initialize Parameters = 2-Wire Initialization, 3-Wire Initialization] to initialize
the drive, A1-12 [Bluetooth ID] is not initialized.
 PRG: 01012 or earlier: The setting value of A1-12 is initialized.
 PRG: 01013 or later: The setting value of A1-12 is not initialized.
3. Revised Default Setting of o1-37 [LCD Backlight ON/OFF Selection]
The default setting of o1-37 [LCD Backlight ON/OFF Selection] is different.
 PRG: 01012 or earlier: 0 [OFF]
 PRG: 01013 or later: 1 [ON]
4. Revised Default Setting of T1-13 [No-load voltage]
The default setting of T1-13 [No-load voltage] is different.
PRG 01012 or Earlier 01013 or Later
Drive Model
B001 to B018
2001 to 2056
4001 to 4031
2070 to 2082
4038 to 4060
B001 to B006
2001 to 2008
4001 to 4004
B010 to B018
2010 to 2082
4005 to 4060
Default value
of T1-13
T1-03 × 0.85 T1-03 × 0.90 T1-03 × 0.85 T1-03 × 0.90
5. Correction of Ferrule Terminal Sizes
Wrong:
Wire Gauge
mm
2
(AWG)
Model L (mm) L1 (mm) φ d1 (mm) φ d2 (mm)
0.25 (24) AI 0.25-8YE 12.5 8.0 0.8 2.0
0.34 (22) AI 0.34-8TQ 12.5 8.0 0.8 2.0
0.5 (20)
AI 0.5-8 WH
AI 0.5-8 OG
14.0 8.0 1.1 2.5