Need help?Do you have a question about the YASKAWA GPD315/V7-4X and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| Model | GPD315/V7-4X |
| Input Voltage | 3-phase, 380-480V AC |
| Cooling Method | Fan cooling |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit |
| Communication Interface | RS-485 |
| Altitude | Up to 1000m above sea level |
| Storage Temperature | -20 to 65°C (-4 to 149°F) |
| Humidity | 5 to 95% RH, non-condensing |
Explains WARNING, CAUTION, and IMPORTANT terms used in the manual.
Lists various drive configurations with their programming requirements and example pages.
Introduces the digital operator for drive configuration and motor control.
Details the meaning of ON, Blinking, and OFF conditions for the RUN and ALARM LEDs.
Lists monitored parameters and their corresponding display examples.
Provides an overview of the drive's capabilities and the manual's scope.
Details environmental and physical requirements for drive installation.
Shows terminal arrangements for main circuit connections across different models.
Details proper grounding procedures for the drive and system components.
Provides notes and wiring diagrams for 2-wire control interconnections.
Offers notes and wiring diagrams for 3-wire control interconnections.
Lists essential checks to perform before applying power to the drive.
Details the procedure for starting the drive using Open Loop Vector control.
Provides the steps for starting the drive using the V/f control method.
Describes how features are defined by parameters and lists them alphabetically.
Explains parameters for setting acceleration and deceleration times.
Explains DC injection braking for stopping or holding the motor.
Allows switching between local and remote control modes.
Details serial communication setup using Modbus protocol.
Explains the use and configuration of multi-function input terminals.
Details stall prevention features to prevent motor stalling.
Explains the PID closed-loop control function for process regulation.
Details the process of copying parameters between drives.
Classifies drive failures into Alarm or Fault categories and describes their indications.
Explains how to view and clear the drive's fault history.
Lists all drive parameters numerically with their settings and references.
Lists specifications related to drive models, including electrical and physical properties.
Details general specifications applicable to all drive types.
Provides dimensional data for NEMA 1 enclosed drives.
Provides dimensional data for NEMA 4 enclosed drives.
Details the installation of dynamic braking options.
Details the installation procedure for a 3% duty cycle braking resistor.
Outlines the installation for a 10% duty cycle braking resistor unit.
Explains how to interpret the drive model number and its components.
Details cover removal for NEMA 4 water/dust tight drives.
To Next Page