Need help?Do you have a question about the YASKAWA GA500 and is the answer not in the manual?
General| Series | GA500 |
|---|---|
| Overload Capacity | 150% for 60 seconds, 200% for 3 seconds |
| Enclosure | IP20 |
| Control Method | V/f Control |
| Braking | Dynamic Braking |
| Communication | Ethernet/IP, Modbus RTU, Modbus TCP, DeviceNet, PROFIBUS, PROFINET |
| Safety | STO (Safe Torque Off) |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault, Short Circuit |
| Humidity | 95% RH or less (non-condensing) |
| Output Voltage | Matches input voltage |
| Storage Temperature | -25 to +70 °C |
Specifies user requirements and provides essential safety instructions.
Explains signal words and defines the approved applications of the drive.
Identifies and explains the functions of the keypad buttons and display.
Guidelines for selecting the installation location and handling covers.
Covers wiring diagrams, wire selection, and control circuit connections.
Steps for initial power-up and basic configuration using setup modes.
Lists and describes key configuration parameters for the drive.
Guides users on diagnosing and resolving common operational issues.
Information on proper disposal and WEEE compliance.
Details on CE Low Voltage and EMC directives, and specific requirements.
Specifies suitable installation locations and operating temperature limits for UL compliance.
Recommended wire sizes and torque specifications for main circuit connections.
Recommendations for branch circuit protection to meet UL standards.
Guidelines for wiring control circuit terminals according to electrical codes.
Parameters for setting motor rated current (FLA) for protection.
To Next Page
