YASKAWA GA500 - Page 7

Document No. EZZ024174
Prepared in August 2020
2
C4-23[Current Control Gain]
PRG: 01013 and Earlier
PRG: 01014 or Later: [RUN] icon removed
You cannot change the parameter setting during Run.
2. Addition of Speed Search Regeneration Determination Parameter
Parameter for setting the regeneration determination level during speed search has been added.
■Added parameter
No.
(Hex.)
Name
Description
Default
(Range)
b3-39
(1B8F)
Expert
Regen
Judgment Lv
of Spd Search
Sets the level to determine the regenerative state during speed
search.
Usually it is not necessary to change this parameter.
15%
(0 - 50%)
If the speed search is not completed after starting the speed search, increase the setting value in 5% increments after
the drive stops.
If the drive detects ov [Overvoltage] during speed search, decrease the setting value in 5% increments after the drive
stops.