7-12 Registers
Drive Parameter Registers continued (Read/Write)
(Continued from previous page)
124h n036 Multi-function Input Selection 0 Reverse Run (2-wire sequence)
(Terminal S2) 1 Forward/Reverse (3-wire sequence)
2 External Fault (N.O.)
3 External Fault (N.C.)
4 Fault Reset
5 Remote / Local Selection
6 Serial Comm/Digital Operator (Freq.
Ref. & run/stop command)
7 Fast Stop Command -Decel 2 (N.O.)
8 Fast Stop Command -Decel 2 (N.C.)
9 Auto Frequency Ref. Selection
10 Multi-step Speed Ref. – Command A
11 Multi-step Speed Ref. – Command B
12 Multi-step Speed Ref. – Command C
13 Jog Command
14 Accel/Decel Time Change Command 0
15 External Base Block (N.O.) (1; if 3-wire)*
16 External Base Block (N.C.)
17 Speed Search from Max. Frequency
18 Speed Search from Set Frequency
19 Parameter Change Enable
20 I Value Reset (PID)
21 PID Control Off
22 Timer Function
23 OH3 (pre-alarm input)
24 Analog Reference Sample/Hold
25 Inertia Ridethrough (N.O.)
26 Inertia Ridethrough (N.C.)
27 Accel/ Decel Ramp Hold
28 PID changeover
To Next Page
Loading...
