7-22 Registers
Drive Parameter Registers continued (Read/Write)
167h n103 Modbus Frequency Reference 0 0.1 Hz/ 1 0
Unit 1 0.01 Hz/ 1
2 100%/ 30000
3 0.01%/ 1
168h n104 Modbus Slave Address 0 to 31 1
169h n105 Modbus Baud Rate Selection 0 2400 bps 2
1 4800 bps
2 9600 bps
16Ah n106 Modbus Parity Selection 0 No parity
1 Even parity 0
2 Odd parity
16Bh n107 Slip Compensation Gain 0.0 to 9.9% 0.0
16Ch n108 No-load motor current 0 to 99% 30
16Dh n109 Slip Comp. Primary Delay
Time Constant
0.0 to 25.5 seconds 2.0
16Eh n110 Operator Connection Fault Detection
Selection
0 Cycle Stop 0
1 Immediate
16Fh n111 Local/ Remote Changeover
Fault Detection Selection
0 Disabled 0
1 Enabled
170h n112 Low frequency
OL start point
0.0 to 6.0 Hz 6.0
171h n113 Continuous operation
level at 0.0 Hz
25 to 100% 50
172h n114 Square Root N Monitor Gain 0 to 99 0
173h n115 KVA selection 00-35 (1)
174h n116 CT/ VT Selection 0 Constant Torque (1)
1 Variable Torque
Notes:
1. Initial value depends on GPD 506 capacity.
To Next Page
Loading...
