YASKAWA GPD 506/P5 - Page 55

7-21 Registers
Drive Parameter Registers continued (Read/Write)
REGISTER PARAMETER
PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex)
FUNCTION SETTING VALUE
159h n089 Limit of Integral Value (PID) 0 to 109% 100
15Ah n090 Feedback Loss Detection (PID) 0 Detection disabled 0
1 Detection enabled
2 Detection enabled w/ fault condition
15Bh n091 Feedback Loss Det. Level (PID) 0 to 100% 0
15Ch n092 Feedback Loss Det. Delay 0.0 to 25.5 seconds 1.0
Time(PID)
15Dh n093 PID Output Selection 0 Not inverted 0
1 Inverted
15Eh n094 Sleep function start level 0.00 to 400.0 Hz 0.00
15Fh n095 Sleep function delay time 0.0 to 25.5 0.0
160h n096 Energy Saving Selection 0 Energy Saving disabled 0
1 Energy Saving enabled
161h n097 Energy Saving Gain (K2) 0.00 to 655.0 (1)
162h n098 Energy Saving Voltage 0 to 120% 75
Lower Limit at 60 Hz
163h n099 Energy Saving Voltage 0 to 25% 12
Lower Limit at 6 Hz
164h n100 Time of average kW 1 to 250 (1=25ms) 1
165h n101 Modbus Timeout 0 Time out detection is disabled 1
Detection 1 Time out detection is enabled
166h n102 Stop Method on Modbus 0 Ramp to stop-Decel 1 (fault) 1
Communication Error (CE) 1 Coast to stop (fault)
2 Ramp to stop-Decel 2 (fault)
3 Continue operation (alarm)
Notes:
1. Initial value depends on GPD 506 capacity.