5.2 Turning ON the Servo Power
5-4
Servo Power ON/OFF --- Enable Switch
When the operator grips the Enable switch, the servo power turns ON. However, if the
operator squeezes the switch until a “click” is heard, the servo power will turn OFF.
When performing emergency stop on the front door of the NX100, programming pendant,
or external signal, the servo power on operation from the Enable switch is cancelled.
When turning the power back on, follow the previously listed instructions.
SUPPLE
-MENT
Release -> OFF Squeeze Tightly -> OFFSqueeze -> ON
Servo On
NOTE
To Next Page
Loading...
