YASKAWA SGD7S-200A - Page 229

9.2 List of Parameters
9.2.2 List of Parameters
9-29
9
Parameter Lists
Pn510
2
Output Signal
Selections 3
0000h to
0666
h
– 0000h All
After
restart
Setup –
Pn512
2
Output Signal Inverse
Settings
0000h to
1111h
– 0000h All
After
restart
Setup –
Pn513
2
Output Signal Inverse
Settings 2
0000h to
0011h
– 0000h All
After
restart
Setup –
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
/NEAR (Near Output) Signal Allocation Reference
0 Disabled (the above signal output is not used).
page 6-5
1 Output the signal from the CN1-25 or CN1-26 output terminal.
2 Output the signal from the CN1-27 or CN1-28 output terminal.
3 Output the signal from the CN1-29 or CN1-30 output terminal.
4 Output the signal from the CN1-37 output terminal.
5 Output the signal from the CN1-38 output terminal.
6 Output the signal from the CN1-39 output terminal.
n.X Reserved parameter (Do not change.)
n.X
/PSELA (Reference Pulse Input Multiplication Switching Output) Signal
Allocation
Reference
0 to 6
The allocations are the same as the /NEAR (Near) signal alloca-
tions.
page 6-5
n.X Reserved parameter (Do not change.)
n.X
Output Signal Inversion for CN1-25 and CN1-26 Terminals
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-27 and CN1-28 Terminals
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-29 and CN1-30 Terminals
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-37 Terminal
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-38 Terminal
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-39 Terminal
0 The signal is not inverted.
1 The signal is inverted.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)