YASKAWA yasnac lx3

4.1.8 CURSOR KEYS
4.1.10
EDIT KEYS
The CURSOR control key is used to move the
cursor . For
example, when a page of parameter
data are displayed by PRM key.
(1) Depressing
‘Y9
key moves the cur-
sor backward.
(2) Depressing ~~uRTSOR ~ key moves the cur-
.
sor forward.
(3) Keeping the cursor control key depressed
makes the cursor move automatically forward
or backward.
—
.
Fig. 4.8
4,1.9
ORG (ORIGIN) KEYS
The ORG key is used
to set the current position
of the machine tool as the Zero point of
coordinate system.
The origin setting can be made for each axis.
The reference coordinate system means the
coor-
dinate system which is set by G92 command or
the automatic coordinate
system setting.
ORG key is used for the following operation.
Reset of current position (Position External/
Absolute)
-
Reset of operation time
These keys are for editing a stored part program.
ERASE key:
Used
for erasure of data in storage.
INSRT key: Used for insertion of data in memory.
ALTER key: Used for
alteration of data in
memory.
MEM OATA
EiEE
d
RES
i~~
EOIT
I[E33] [Fw=kql
I
Fig. 4.9
4.1.11 MEM DATA (MEMORY DATA) KEYS
TAPE KEYs are to start the tape operation except
in the automatic operation mode.
They are effec-
tive only in the EDT mode.
(1) OUT key
This key
is to start outputting various
in memory through data I/0 interface.
(2) IN key
data
This key is to start storing various data
into memory through tape reader or data
1/0 interface.
(3) VER key
This key is to start verifying between mem-
ory data and punched tape data.
154