Edit
System
Operation
No.
~ ode Func - I
Lc’ck
Switch
Procedure
tion ;
Address search
Specified part program
Cleal ——————
-–ems —
k
Address search
r
m .—
n
,=
Designated part program
Cleal
All part programs on tape
1
MEM I
EDIT
I
Data of the searched address +
——
CURSO~
OddEDIT‘p%--- ‘“
~+ program number to be cleared - LERASE ~
OFF
1
I
~
MEM
EDIT
+
OFF
EDIT
OFF
I
,
I
Notes.
*1
*2
*3
*4
If the tape contains setting information, it is also stored and
matched at the same time.
When data has been stored from a parameter tape, turn the
power on and off.
Setting is punched out at the same time.
Storing of a part program having a program number different from
~ogram number O on tape is performed by the same operation as
for “tape without Wogram number ‘J.”
— -—
ALM ~ ~
0-+ – 9999- ERASE
i Addres S data to be searched - ~“U~S-ORl
.—. —
PROG
~F1 “-
+ program number to be searched +
~RAS~
ALM ~:-.,
I ?-,
-– 9999-’
Lx!@
*5
*6
Within the limit of 32 characters, addition of multiple address
data and the change to one address data are permitted,
When the cursor to the address data in the middle of a
block and EOB and ERASE keys are depressed, the data
following the cursor position is deleted,
5. MACHINE CONTROL STATION
5.1 SWITCHING UNITS ON THE CONTROL
STATION
Fig. 5.1 shows a typical layout of switching units
on the machine control station.
For details, re-
fer to the machine tool builder’s manual.
5. 1.1 MODE SELECT SWITCH
This switch selects operation mode of the NC
system and consists of 6 positions (JOG, HAN–
DLE, TAPE, MDI, MEM, EDT) .
(1) JOG:
To feed the tool continuously by
manual operation.
Feedrate is set by
FEEDRATE OVERRIDE switch.
(2) HANDLE/STEP:
To feed the tool by opera–
ting the manual pulse generator’f. Where
the control is not provided with a manual
pulse generator, the tool is fed by step
manually operating the JOG PUSHBUTTON (S),
(3)
(4)
(5)
(6)
TAPE :
To automatically control the NC
sY5tem with NC tape.
MDI :
To enter the block of data through
the DATA keyboard and control the system
automatically with the data.
MEM :
‘To automatically control the system
with the stored part program.
EDT :
To store the part program into mem-
.-
ory and edit the part progra-m.
CYCLE FEED
START
HOLE
7. D=
!-! L
la
b
@)
MDI
HANDLEI
MEM
STEP
0
JOG
EDT
RAPID
187
To Next Page
Loading...
