6.10 PREPARATION FOR TURNING OFF POWER
(1) Make sure that the machine is at standby
and CYCLE START lamp is extinguished.
(2) Check to see that NC ALARM is not indicat-
ed on CRT.
If alarm is displayed, detect
the causes of displayed alarm code and
eliminate them.
Refer to 4.3.9, “ ALARM CODE
DISPLAY.”
(3) Inspect the machine referring to the machine
tool builder’s manual.
6.11 TURNING OFF POWER
(1) Depress EMERGENCY STOP pushbutton to
turn off the servo power supply.
(2) Depress POWER OFF pushbutton on the op-
erator’s panel to turn off the control power
supply .
(3) Cut off the main power supply from the con-
trol.
217
To Next Page
Loading...
