Yealink CP930W - Connect a Mobile Device; Pair + Connect Bluetooth-Enabled Mobile Phone

10
PAIR AND CONNECT A BLUETOOTH-ENABLED MOBILE PHONE
The YeaLink phone cannot scan the Bluetooth devices, so you will need to pair and connect the phone from your Blue-
tooth enabled mobile phone.
Before you begin, make sure you have activated the Bluetooth mode and made the phone “discoverable”.
TO ACTIVATE
+ Tap the Bluetooth icon.
+ Select On from the Bluetooth field.
+ Select SAVE.
TO PAIR
+ Follow the procedure to scan and pair the phone for your Bluetooth-enabled phone.
+ The default device name of your phone is “Yealink- CP930W”.
ENABLE PHONE AUDIO
When you enable the phone audio, the phone can act as a speaker and microphone for your connected mobile phone.
The call is made through your mobile phone but the audio is present on the Yealink phone and the call is controlled by the
Yealink phone.
TO ENABLE
+ Tap the Bluetooth icon.
+ Go to Options > Detail > Channel Control.
+ Select Enabled from the Media Audio field.
+ Select SAVE.
HANDLE A MOBILE CALL ON YEALINK
You can handle a mobile call on the Yealink phone. The Yealink will act as a speaker and microphone for your mobile
device.
TO PLACE A CALL
+ Press the DIAL key.
+ Press SWITCH Softkey.
+ Select MOBILE ACCOUNT.
TO ANSWER A CALL
An incoming call to your mobile phone will also display on the YeaLink phone
+ Press the ANSWER key,
During the call you can hold/resume, mute/unmute or end the call from the Yealink phone.
Need support? Connect with us at www.northland.net/support or
Dial 4357 (HELP) or 315-671-6262 to speak to a Northland Training Representative